Problem 521
In Fig. P-519, if μ = 0.30 under both blocks and A weighs 400 lb, find the maximum weight of B that can be started up the incline by applying to A a rightward force P of 500 lb.
 

Problem 520
Referring to Fig. P-519, block A weighs 4 kN and B weighs 3 kN. If μ = 0.20 under B, compute the minimum coefficient of friction under A to prevent motion.
 

Problem 519
In Fig. P-519, two blocks are connected by a solid strut attached to each block with frictionless pins. If the coefficient of friction under each block is 0.25 and B weighs 2700 N, find the minimum weight of A to prevent motion.
 

Problem 516
Referring to Fig. P-515 if the coefficient of friction is 0.60 and θ = 30°, what force P applied to B acting down and parallel to the incline will start motion? What is the tension in the cord attached to A?
 

Problem 515
Block A in Fig. P-515 weighs 120 lb, block B weighs 200 lb, and the cord is parallel to the incline. If the coefficient of friction for all surfaces in contact is 0.25, determine the angle θ of the incline of which motion of B impends.
 

Problem 514
The 10-kN cylinder shown in Fig. P-514 is held at rest on the 30° incline by a weight P suspended from a cord wrapped around the cylinder. If slipping impends, determine P and the coefficient of friction.
 

Problem 513
In Fig. P-512, the homogeneous block weighs 300 kg and the coefficient of friction is 0.45. If h = 50 cm, determine the force P to cause motion to impend.
 

Problem 512
A homogeneous block of weight W rests upon the incline shown in Fig. P-512. If the coefficient of friction is 0.30, determine the greatest height h at which a force P parallel to the incline may be applied so that the block will slide up the incline without tipping over.
 

Problem 511
Find the least value of P required to cause the system of blocks shown in Fig. P-511 to have impending motion to the left. The coefficient of friction under each block is 0.20.
 

Problem 510
What weight W is necessary to start the system of blocks shown in Fig. P-510 moving to the right? The coefficient of friction is 0.10 and the pulleys are assumed to be frictionless.