Problem 533
A uniform bar AB, weighing 424 N, is fastened by a frictionless pin to a block weighing 200 N as shown in Fig. P-533. At the vertical wall, μ = 0.268 while under the block, μ = 0.20. Determine the force P needed to start motion to the right.
Problem 532
In Fig. P-532, two blocks each weighing 1.5 kN are connected by a uniform horizontal bar which weighs 1.0 kN. If the angle of friction is 15° under each block, find P directed parallel to the 45° incline that will cause impending motion to the left.
Problem 531
A uniform plank of weight W and total length 2L is placed as shown in Fig. P-531 with its ends in contact with the inclined planes. The angle of friction is 15°. Determine the maximum value of the angle α at which slipping impends.
Problem 530
A plank 10 ft long is placed in a horizontal position with its ends resting on two inclined planes, as shown in Fig. P-530. The angle of friction is 20°. Determine how close the load P can be placed to each end before slipping impends.
Problem 529
As shown in Fig. P-529, a homogeneous cylinder 2 m in diameter and weighing 12 kN is acted upon by a vertical force P. Determine the magnitude of P necessary to start the cylinder turning. Assume that μ = 0.30.
Problem 527
A homogeneous cylinder 3 m in diameter and weighing 30 kN is resting on two inclined planes as shown in Fig. P-527. If the angle of friction is 15° for all contact surfaces, compute the magnitude of the couple required to start the cylinder rotating counterclockwise.
Problem 528
Instead of a couple, determine the minimum horizontal force P applied tangentially to the left at the top of the cylinder described in Prob. 527 to start the cylinder rotating counterclockwise.
Problem 526
A ladder 6 m long has a mass of 18 kg and its center of gravity is 2.4 m from the bottom. The ladder is placed against a vertical wall so that it makes an angle of 60° with the ground. How far up the ladder can a 72-kg man climb before the ladder is on the verge of slipping? The angle of friction at all contact surfaces is 15°.
Problem 525
A uniform ladder 4.8 m ft long and weighing W lb is placed with one end on the ground and the other against a vertical wall. The angle of friction at all contact surfaces is 20°. Find the minimum value of the angle θ at which the ladder can be inclined with the horizontal before slipping occurs.
Problem 524
A horizontal arm having a bushing of 20 mm long is slipped over a 20-mm diameter vertical rod, as shown in Fig. P-524. The coefficient of friction between the bushing and the rod is 0.20. Compute the minimum length L at which a weight W can be placed to prevent the arm from slipping down the rod. Neglect the weight of the arm.
Problem 523
A force of 400 lb is applied to the pulley shown in Fig. P-523. The pulley is prevented from rotating by a force P applied to the end of the brake lever. If the coefficient of friction at the brake surface is 0.20, determine the value of P.
