Problem 814 | Continuous Beam by Three-Moment Equation
Problem 814
Find the moment at R2 of the continuous beam shown in Fig. P-814.
- Read more about Problem 814 | Continuous Beam by Three-Moment Equation
- Log in or register to post comments
December 2012
Problem 813 | Continuous Beam by Three-Moment Equation
Problem 813
Determine the moment over the support R2 of the beam shown in Fig. P-813.
- Read more about Problem 813 | Continuous Beam by Three-Moment Equation
- Log in or register to post comments
Problem 729 | Uniform load over the center part of fixed-ended beam
Problem 729
For the restrained beam shown in Fig. P-729, compute the end moment and maximum EIδ.
Problem 728 | Isosceles triangular load over the entire span of fully restrained beam
Problem 728
Determine the end moment and maximum deflection of a perfectly restrained beam loaded as shown in Fig. P-728.
Problem 727 | Fully restrained beam with uniform load over the entire span
Problem 727
Repeat Problem 726 assuming that the concentrated load is replaced by a uniformly distributed load of intensity wo over the entire length.
Problem 726 | Fully restrained beam with concentrated load at midspan
Problem 726
A beam of length L, perfectly restrained at both ends, supports a concentrated load P at midspan. Determine the end moment and maximum deflection.
Problem 725 | Propped beam with partially restrained wall and settling simple support
Problem 725
If the support under the propped beam in Problem 724 settles an amount $\delta$, show that the propped reaction decreases by $3EI\delta / L^3$.
Problem 724 | Propped beam with partially restrained wall support
Problem 724
The beam shown in Fig. P-724 is only partially restrained at the wall so that, after the uniformly distributed load is applied, the slope at the wall is $w_oL^3 / 48EI$ upward to the right. If the supports remain at the same level, determine $R$.
Problem 723 | Propped beam with uniform load over half the span
Problem 723
Find the reaction R and the moment at the wall for the propped beam shown in Fig. P-723.
